Sunday, December 13, 2015

English Gown, take 1

I finished my English Gown last week.  This is the J.P. Ryan pattern.  It's pretty straightforward as it is a solid front with no stomacher.  Altering this pattern was a little difficult however due to the fact that there are no side seams.  The bodice is one piece for the front, side and side back then there is a narrow center back piece.  After careful measuring with my stays, I ended up combining two sizes, which meant buying 2 patterns.  I used the 8 on the bust and the 10 for the waist and sleeves.  I chose not to follow the construction directions however as they instruct you to make up the bodice with the sleeves and to do the same with the lining, then bag the lining.  This is not a period correct construction and since I was making this garment completely by hand, I decided to go with accurate construction methods.

I followed this article for setting in the sleeves and constructing the bodice.  Basically, I constructed the bodice without the shoulder straps and sleeves and the lining the same way.  I stitched them together at the center front then I stitched the lining shoulder strap in.  The sleeves are lined and put in at this point with the bottom of the sleeve attached seam inside.  Then the seam is shifted to the outside and stitched on top of the shoulder strap.  Three pleats are put in the back of the sleeve cap to make the sleeve fit.  After the sleeve is attached, the fashion fabric shoulder strap is attached.

Bodice seams were sewn with a combination stitch comprised of running stitches with an occasional backstitch.  The sleeves were attached with backstitches for strength.  Long skirt seams were sewn with running stitches.  The skirt and shoulder straps were attached with lapped seams with whip stitches.   The skirt pleats were formed freehand--something I've gotten quite good at doing.  I'm pleased with the final result.  Due to time constraints I chose to use hook and eye tape which takes away from the authenticity of this gown.  Otherwise, it's dead on correct.  I also regret not putting boning at the center back.

The materials used were:  Williamsburg cotton print from Renaissance Fabrics, white linen for lining from Burnley and Trowbridge, silk thread, steel boning, hook & eye tape.   Petticoat materials:  cotton matelasses from Renaissance Fabrics,  linen tape from Burnley and Trowbridge.

Front shoulder strap

back shoulder strap showing sleeve pleats

front facing with hook & eye tape

lining sewn to skirt

back bodice showing skirt pleats

sleeve lining

I wore the gown over a matelasse petticoat which was worn for warmth.  It had enough body to not need a hip roll.  The matelasse was 60 inches wide so I used two lengths, sewed the side seams with a running stitch and tacked down the pocket openings.  I pleated the top using fewer but larger pleats than normal--a 4 inch box pleat in the center front and a 4 inch inverted box pleat at the center back.  Typically I would have about 26 pleats in the front but I had about 10.   The top was bound with 1 inch wide linen tape whip stitched to the outside and inside of the petticoat.

front pleats

back pleats

Here are the pics of the gown:


At the Carlyle House in Old Town Alexandria VA

With my soldier


2 comments:

  1. Lovely and thank you for including details about where you got your fabrics.

    ReplyDelete
  2. Lovely and thank you for including details about where you got your fabrics.

    ReplyDelete